Ohaus I150-S Indicator User Manual download pdf (Page 48)

Hole Plug

Closing the CoverClosing the Cover

Closing the Cover

When all connections and settings have

been made, close the cover and fasten

the four cover clamps.

Insert a hole plug (included in accessory

kit) in each liquid tight connector seal

bushing which is not being used, and

tighten the bushing.

Seal

Wire

LFT SEALINGLFT SEALING

LFT SEALING

After the indicator and load receiver have

been evaluated and accepted by a weights

and measures official, the indicator must

be sealed as follows:

1. Pass the calibration seal wire through

the small hole in the lip of the cover,

then through the clamp and bracket.

2. Pass the end of the wire through the

lead seal.

3. Seal the unit by squeezing the lead

seal over the wire.

OPERATIONOPERATION

OPERATION

Selecting a Weighing UnitSelecting a Weighing Unit

Selecting a Weighing Unit

To select one of the available weighing

units for use,

repeatedly press UNITS until the desired

indicator appears on the display.

If the desired unit indicator does not ap-

pear, refer to “Unit Selection” in the

“SCALE SUBMENU” section.

SETUPSETUP

SETUP

UNITSUNITS

UNITS

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 75 76

No comments

Ohaus I150-S Indicator User Manual Page 48