Ohaus I150-S Indicator User Manual download pdf (Page 52)

52

Parts CountingParts Counting

Parts CountingParts Counting

Parts Counting

Parts counting enables you to place a

batch of similar parts on the platform

while the indicator displays the total num-

ber of parts. To use this function, the parts

must be reasonably uniform in weight.

The accuracy of your results will be deter-

mined by the error level that was entered

in “PC Err” of the scale submenu.

LFT NOTE:LFT NOTE:

LFT NOTE:LFT NOTE:

LFT NOTE: This feature is not available

when LFT is set to ON.

A press-on label (“PCS”) for parts count-

ing is included in the accessory kit. It

should be affixed to the blank button next

to the FUNCTION button on the keypad.

The following procedure assumes that a

container of some sort will be used to hold

the parts. If this is not the case, simply

ignore step 1.

1. Place an empty container on the load

receiver and press TARE to tare the

weight of the container, or

if the empty container weight is known,

enter the weight using the numeric

keypad, then press TARE.

2. If the average piece weight of a single

part is known, enter the weight using

the numeric keypad, press FUNC

then press PCSS and proceed to

step 4.

If the average piece weight is un-

known, place a sample number of

pieces in the container or on the load

receiver.

Enter container tare

weight if known.

Enter average piece

weight if known.

TARETARE

TARETARE

TARE

TARETARE

TARETARE

TARE

FUNCTIONFUNCTION

FUNCTIONFUNCTION

FUNCTION

APWAPW

APWAPW

APW

PCSPCS

PCSPCS

PCS

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 75 76

Comments to this Manuals

No comments