Ohaus I150-S Indicator User Manual download pdf (Page 8)

8

6. After the connections have been

made, fasten two cable ties (included

in the accessory kit) around the power

cord as shown in the diagram. The

cable ties secure the power cord so it

cannot be pulled out of the enclo-

sure.

7. Tighten the seal bushing until resis-

tance is felt against the cable. Turn

the cap nut an additional full turn to

secure the cable.

Cable Ties

Load Receiver

#2

Load Receiver

#1

Load Receiver ConnectionsLoad Receiver Connections

Load Receiver ConnectionsLoad Receiver Connections

Load Receiver Connections

Using a small screwdriver, connect the

load cell cable to TB1 located on the main

circuit board inside the enclosure as fol-

lows (see diagram):

1. Pass the cable from the load

receiver(s) through one of the two

liquid tight connector(s) seal bush-

ings on the lower left of the enclo-

sure.

2. Make the connections according to

the markings on the circuit board.

3. After the connections have been

made, tighten the seal bushing until

resistance is felt against the cable.

Turn the cap nut an additional full

turn to secure the cable.

NOTE: Remote sensing is available only

on load receiver #1. Load receiver #2 may

not be used.

For Ohaus LB, PL and WB platforms,

leads are color coded as follows:

Black: EXC (-) Green: EXC (+)

White: SIGNAL (-) Red: SIGNAL (+)

Yellow: SENSE (-) Blue: SENSE (+)

For Ohaus WBS platforms:

Black: EXC (-) Red: EXC (+)

White: SIGNAL (-) Green: SIGNAL (+)

SENSE connections from Load

Receiver #1. (Load Receiver #2 IS

NOT USED)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 75 76

Comments to this Manuals

No comments