Ohaus I150-S Indicator User Manual download pdf (Page 3)

PREFACEPREFACE

PREFACE

The I150 Electronic Indicator is a highly versatile device which is designed for a variety

of applications. It can be used with virtually any load receiver which provides a

compatible output signal. This instruction manual contains the information needed to

install, configure and operate the I150. Read it before attempting to operate the

indicator.

The I150 is a software controlled indicator with a host of user-programmable features.

Calibrating and setting up operating parameters are easily accomplished using the

front panel keypad and display. These are a few of the standard features included with

the indicator:

RS-232 Interface: RS-232 Interface:

RS-232 Interface: The bi-directional RS-232 interface enables the indicator to

communicate with printers and computers. Instructions on connecting and using the

interface are included in this manual.

Parts Counting: Parts Counting:

Parts Counting: The parts counting feature allows you to count parts in a number of

ways. You can enter the average piece weight and start counting, or let the indicator

perform averaging and display the count.

Single/Dual Platform Operation: Single/Dual Platform Operation:

Single/Dual Platform Operation: The I150 is a two-channel indicator which permits

you to monitor two load receivers. Switch to either load receiver by pressing a single

button.

Checkweighing and Filling: Checkweighing and Filling:

Checkweighing and Filling: Set point indicators and digital outputs are provided for

these applications. In checkweighing, the indicators and digital outputs correspond to

OVER, UNDER and ACCEPT values. In filling processes, they can be used to activate

preset feedrates and cutoff points of filling devices.

ClassificationsClassifications

Classifications

Both models I150-P and I150-S have been tested and certified to comply with the

following regulations:

Weights and MeasuresWeights and Measures

Weights and Measures

• National Institute of Standards and Technology Handbook 44 Class III and IIIL

• Consumer and Corporate Affairs Canada Weights and Measures Act and Regula-

tions general class.

SafetySafety

Safety

• Underwriters Laboratory 114 and 466

• Canadian Standards Association C22.2 No. 151-m1986

• National Electrical Manufacturers Association Standard 250 Type 4 (NEMA 4)

• International Electrotechnical Commission Pub. 529 Index of Protection 65-(IP65)

• DIN VDE 0411

LEGAL FOR TRADE NOTELEGAL FOR TRADE NOTE

LEGAL FOR TRADE NOTE

Throughout this manual, the abbreviation “LFT” represents “Legal For Trade”.

1 2 3 4 5 6 7 8 ... 75 76

Comments to this Manuals

No comments

Ohaus I150-S Indicator User Manual Page 3

Comments to this Manuals

Related products and manuals for Scales Ohaus I150-S Indicator