Ohaus I150-S Indicator User Manual download pdf (Page 38)

3. The display will show “buSY” while

the I150 reads the first calibration

point, and then show “C XXXX” indi-

cating the value of a load which must

be applied to the load receiver.

• If the value is greater than 4 digits,

the display will show “C Pt” in

place of the value.

• If 3-point linearization is being per-

formed (a linearization point was

selected in the “SEtUP” submenu),

and the value is greater than 4

digits, then “L Pt” will be displayed.

4. Apply the required load to the load

receiver, and then press ENTER.

5. The display will again show “buSY”

while the I150 reads the calibration

point.

- If span calibration is being per-

formed (no linearization point

was selected in the “SEtUP” sub-

menu), proceed to step 9.

- If 3-point linearization is being

performed (a linearization point

was selected in the “SEtUP”

submenu), continue with step 6.

6. The display will show “C XXXX” indi-

cating the value of the next load

which must be applied to the load

receiver. “C Pt” will be displayed if

the value is more than 4 digits.

ENTERENTER

ENTER

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 75 76

No comments

Ohaus I150-S Indicator User Manual Page 38